...to have taken the board out. The main board is speculation, but I think I am correct, sorry, Dave Your problem is the network card - take it out and the problem should go away.. Don Bristolprinters ...
Question about IDP Upgrade Kit for ISG 2000 system, including IDP Lic Key, additional memory, and 5-device NSM (NS-ISG-2000-IKT) Firewall
...board are in good condition and connected correctly and securely. error 60 means connection to cxd player interupted,no supply voltage present for decoder board ,check cables to decoder board and ...
...Board Unplug network Cable or Parallel Cable from the printer and then turn it off and then on, if error goes away then it was a bad communication from the network or the computer This usually solves ...
...board ? Bad network cable ? Replace firmware DIMM ? Replace the jet direct card ? Replace formatter board ? Replace engine board 95% of the time it is a PDF that has a font that is not recognized by ...
...board. If you take the controller board out (it's the board that the usb/network cable plugs into). You find 2 banks. Ones for memory, the other bank is your prom board they refer to as a
...If the error doesn't come back up swap the network cable, with a good one. 2.) Firmware upgrade 3.) Replace the system board Based on my experience it's either the network cable or the system
...f-01 F10 00 Printer board problems 01 Printer board problems 02 Printer board problems 03 Network card error 04 Firmware error 05 Not enough memory 10 Printer board problems 90 Printer board ...
...board (the network port is built in it). If the printer works just fine while unplugged from the network, start replacing the network cable, otherwise you need to look into your network (end quotes). ...
...bad formatter board (the network port is built in it). If the printer works just fine while unplugged from the network, start replacing the network cable, otherwise you need to look into your
...000716.give me answer. That error code is a communication error. Check all the connections inside to the main board and the network board. This error might require you to replace one of those
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions