...choke. I assume the original problem was that the bike would not idle .If this is the case, take the carb apart remove the slow jet and clean the jet and the carb body out so fuel will flow at idle. ...
new cable through the frame following the exact same route as the old cable and connect it to the carbs and check the opperation of the choke lever, pulling it on and off making sure when the choke is
...new carb seal where the carb pushes back into the intake. Make sure the throttle works smoothly and snaps shut when you relaease the throttle grip. Never lubricate the "choke" cable. Be careful when ...
...Once you get the carb off, you can take a 14mm wrench to remove the choke cable, swap the plunger and spring onto the new cable and reinstall it into the carb. Put the carb back on the engine. ...
...choke cable where it goes into the carb. You'll have to take the plunger and spring off the old cable and put it on the new cable. The screw it back into the carb. Reconnect the throttle cables and ...
...New choke wires are expensive! spray white lithium grease into the choke assemply up at the handle, then follow the cable down to the engine, extend the choke cable inside the outer cable housing and ...
Question about 2001 FXD Dyna Super Glide
...new seal. Put the choke cable in it's bracket and secure the nut. Be careful and do not over tighten the nut as the plastic cable housing will break. Reconnect the fuel line, the vacuum line, and ...
choke is stuck on pw50, cable is bent remove the cable and make or buy a new one ( depending on the fittings could use a pushbike brake cable and solder ) If the choke lever on the carburetor is ...
...new bikes have a automatic choke ,but if you look at the carburetor you should see 2 cables 1 is the throttle cable the other is the return cable both run up to the throttle hand control (some bikes ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions