...repair myself and desoldered the voltage regulators with the 5 legs off the board. i found it easier to cut the legs off first as the heat from the soldering gun was lost through the component.I also ...
...repair. I would guess that bad capacitor(s) in the power supply lines going to the logic section of the main PCB could cause the symptoms you're experiencing. Good Luck. Hi, I took advice from this ...
...the power supply board (Pioneer will sell only the complete board). I ordered the IC from the UK (nikko-electronics.co.uk) GBP8.99 which was the only place I could find it online and soldered it in ...
repair is best left to someone who is. Ok...the fault you describe is caused by failure of IC001. This is a voltage regulator on the power board. You can identify the regulator as it is fixed to along
Nikko Electronics will supply the component or there are other suppliers. I have given full instructions >HERE< to repair the DMR E55. The E85 is not exactly the same, but its very similar and it will
Question about STIRLING PLATINUM NIGHTEATER RIFLE SCOPE -- 1"Power: 6X36 / Reticle
...Nikko Stirling Nighteater 10x50x60, FT and while using it at the gun club yesterday a fluid type stain appeared on the lens. It appears to be internal and cannot be removed by cleaning the lenses and ...
Question about STIRLING PLATINUM NIGHTEATER RIFLE SCOPE -- 1"Power: 6X36 / Reticle
...Nikko. You may have the smell saturated in the door or cabinet insulation. If it is a musty smell it and it is coming from the door itself you may end up replacing the door insulation or the door. (A ...
Question about STIRLING PLATINUM NIGHTEATER RIFLE SCOPE -- 1"Power: 6X36 / Reticle
nikko repair shop my ford harley davidsonf150 is not working tried swaping batteries i think its the moter i dont under stand ... my grandpa gave it to me and he would be mad if i told him i broke it ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions