Questions & Answers for: nissan distributor rotor

distributor off take notice of rotor button location.If you already removed the old distributor locate number one cylinder and point rotor button to that cylinder. it might have to be done a couple of

...nissan frontier going down the highway and just shuts off when i took the distributor cap off the rotor button was not turning as i turned the truck over is that a bad distributor I'm not familiar ...

nissan pick. I moved the distributor when I was removing the front cover and now it won't start. How do I fix this? find top dead center on clyinder 1 a good way to do this is take off valve cover and

Nissan 300zx seems to be "missing". suspect 1) bad spark plug(s) - change whole set if needed, (2) failing ignition coil (3) failing distributor component(s), or (4) worn out distributor cap

Nissan Frontier, the distributor rotor doesn't turn? This is an indication that the gear at the base of the distributor has broken. More seroius situation would be a broken gear on the cam. If the

...Nissan Pickup Can't get Distributor Rotor off. What's the trick to getting it off? if this is a push on type rotor then they get stuck/bonded to the distributor shaft and if you use a pair of ...

...distributor on 2000 nissan pathfinder Hi there;This is for a 2000 Nissan Truck Pathfinder 4WD 3.3L SFI 6cylDistributor Cap & Rotor - Removal & InstallationNOTEThe 1996-00 3.3L engines ...

...but wont start rotor dont turn If you mean the rotor inside the distributor, either the rotor screw fell out, or the distributor gear is broke, or the timing belt broke and the cams are not

...nissan service manual. Normally you move the crank to TDC for cylinder #1 and point the distributor rotor toward that wire. You may have to clock the rotor a bit against rotation so it ends up ...

...Nissan Xterra, it is idling rough and has almost no power. It already has new distrubutor cap and rotor, plugs and wires. Also replaced the crank sensor by the bell housing. Im pulling code p0340 and ...