Questions & Answers for: Chrysler 300M oil tube

...car at least until you get th cap fix. thake the dipstick out of the tube and put a funnel in it and ad the oil tha way. at least you have the oil in the car and your not chancing running the

...OIL IN THE TUBE ON THE LEFT BANK FACING THE FRONT, ON THE REAR CYLINDER. PULLED THE PLUG OUT, AND IT WAS COVERED WITH OIL. LOOKED DOWN THE TUBE AND THERE WAS OIL IN IT AT THE BOTTOM. I'M SURE IT ...

...tube flange over two studs. Install nuts. Tighten retaining nuts to 53 inch lbs.(6 Nm). Tighten starter bolt to 40 ft. lbs. (54.3 Nm). Connect the lower radiator hose to the thermostat housing. ...

OIL cooler. If yu change the radiator, be very careful when removing the lines. They can be expensive, and you DON'T want to have any leaks. (this is for future readers, since this was in 2009.)If

...tube flange over two studs. Install nuts. Tighten retaining nuts to 53 inch lbs.(6 Nm). Tighten starter bolt to 40 ft. lbs. (54.3 Nm). Connect the lower radiator hose to the thermostat housing. ...

...oil cooler connections (if equipped), and fan wiring connector, remove the fan module (four fasteners on the corners, two clips at the middle top and bottom). Use care to avoid bending the condenser ...

There is an Oil pressure sending unit on the left front side of the engine. This is connected to a special fitting that has the tubing that goes to the oil cooler. This is leaking. Where can I get one

...tube to the oil line and the oil switch. they then put these parts back on the car. I then tried to jump it again and it still would not start. I removed and fully charged the battery to see if this ...

...engine everything ok. a few min. later the same thing. 200,000 mi on vehicle Have you changed the oil filter? If no, try that. If yes, then pull off the oil pan and clean out the pick-up tube

...tube blockage i use an IR pyro gun to find these. there are 3 more tests, ask. You most likely have a bad head gasket. When the gasket goes bad you can have antifreeze mix with the oil or pressure ...