Questions & Answers for: open airbox

Question about 2008 C30

1 Answer

...open the hood...you should see the airbox right there near the bumper area. There should be two Phillips screws on the airbox facing up right in the center. Unscrew those two, but don't go so far to ...

Ad

Question about 2005 Stryker 125

1 Answer

engine Ok i opend up the airbox on my moped hoping to uncork it a bit then i rode it and it bogs out now i realize that it needs to get more gas and have the exhaust opened up too do i have the right ...

Ad

...open, when the throttle is opened up, after a few seconds the airbox starts gushing out a gas/oil mix. Bike is actually an XJ 550 model. Please visit this site there's a lot of information on all XJs ...

Question about 2005 YZF 600 R thunder cat

2 Answers

...open the airbox, you lose that ram air effect and your engine runs rich, causing the poor performance. Put the cover back on and make sure it is secure and sealed. Your bike was designed to have the ...

...open airbox, remove bolts inside and take it off, then you see the plugs! Be carefull not to damage any connectors or the coil, use a 16 mm socket, 5/8", and more extensions! It could help if some of ...

...have a hole in the air filter or no filter, CV's need to have the original airbox or be jetted if openned, so if has a leak airbox side of carbies will run great in neutral but will miss badly

...to the carb cover - open it and remove the bolts that hold the carb directly to the airbox - it should slide out to the passenger side of the bike if you remove the one vent hose from the

Question about 2008 FLHX Street Glide

1 Answer

...bike same year and model with same cams. Check exhaust flapper on downpipe assy. Make sure it opens and closes when revving bike. This can be de-activated to improve acceleration. Also check ...

...airbox open, if the airbox is filling with oil with the engine running see where its coming from. If you can't see any oil going into the airbox its probably filling very slowly and then pours out ...

Question about 2008 FLHX Street Glide

1 Answer

open. The correct position to set the slide height is on the airbox side of the carburetor slide. When the throttle slide is set too high on the engine side, it can cause the bike to idle high, as you

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...