...water pump to the heater core the other is connected at the engine to the heater core) one hose may have a regulator (a small mechanical device operated by either cable,electric,or vacuum that ...
outlet tube! Work around the hose on the tube. Eventually you will get it broke loose, where you can twist it off of there. 2.Radiator hose? Same thing applies here as listed above. I HAVE used a flat
water trap,on the pre fuel filter on it's top there is a feed pump for the diesel ,now what you must do is to see for the diesel hoses ,follow it ,you will find inlet and outlet for the hoses,you must
...of radiator to engine. It attaches to thermostat/water outlet housing. Remove hose clamp. Remove two bolts beneath hose that attach housing to intake manifold. Under this housing is your
...outlet for the haeter core, ( which is located on the fire wall in the engine compartment ), cut 2 or 3 inches off of the end of hose and then slide it back on and clamp it. Without the benefit of ...
outlet hose to the water pump. Position the outlet hose clamp at the water pump. NOTE Important: Align the arrow at the throttle body end of the duct with the throttle body attaching stud. Install the
Usually answered in minutes!
550 Questions
469 Questions
461 Questions
355 Questions
338 Questions