Questions & Answers for: Dodge Dakota pcm plug

Question about 2000 Dakota Quad Cab

1 Answer

...plug wire..faulty ignition coil pack..faulty PCM...open or short in wiring from PCM to iginition coil pack. To accurately troubleshoot and determine the problem you will need an oscilliscope and a ...

Ad

...PCM. Intermittent failure in the plug would cause these cascade codes with a misfire. I would inspect the plug and make sure there is a good verifiable ground from the cab to the frame even to the ...

Ad

...your new ECM and adapt it to your car I forgot to mention that I supplied my VIN number and mileage to the seller from whom I bought the PCM. They pre-programmed it so that I could plug it in and

...PCM other than the one installed will need to be programmed. modulemaster.com may be able to rebuild for a couple hundred bucks but the car will be down for 10 days or so. If they can rebuild it its ...

plug wire, but it sound to me like your pick up coil is going bad, pick up coil sit under the distributor cap under the distributor rotor same size as distributor assembly ( black ) cheap$$, good luck

Question about 1998 Dakota

1 Answer

...my Dakota. I also have replaced the same things as you and narrowed it down to the O2 sensor or the PCM but was not willing to pursue it because of $$$. I found that I could replicate the problem at ...

...the engine cranking or running.  This DTC will be stored in the Powertrain Control Module (PCM) when the PCM FAILURE COUNTER reaches 96 failures for 2 consecutive trips.Posiible causes are: ...

PCM (powertrain control module). It eliminates the need for spark plug wires by putting the coil right above the sparkplug. Two wires are dedicated to each coil. One is a battery feed usually from the

Question about 1998 Dakota

1 Answer

...plug Engine stalls andengine code 920, 921 and 999 show in info center. Also "no bus" sounds like your PCM is going, Dodges are known for this, most of the time the circuit board inside cracks, and ...

...relay get power but no start and get code for no rpm If you're getting a code for no RPM, the PCM is not receiving a signal from the crankshaft position sensor. The PCM uses the signal from the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2001 Dodge Dakota
2001 Dodge Dakota

1,021 Questions

1998 Dodge Dakota
1998 Dodge Dakota

870 Questions

1997 Dodge Dakota
1997 Dodge Dakota

712 Questions

1995 Dodge Dakota
1995 Dodge Dakota

723 Questions

1992 Dodge Dakota
1992 Dodge Dakota

618 Questions

Manuals & User Guides

Loading...