Questions & Answers for: plastic dog ears washer

...plastic cup over the rod has a square insert which my 5/8 in. flat wood drill bit fit into. Turned it counter clockwise and unscrewed and removed the plactic cup. Then the cam assembly with the ...

...dog ear retainer....now take your socket to place bolt back on,put some plastic wrapper or package from dogs in the socket and push the bolt into it.then place the bolt in the hole of the dog ear ...

dog aggitation ears are what cause the aggitator to aggitate. Those things wear down and not grab after time. Pretty easy to change out. You just need to pull the aggitator out and change the 4 little

dog ear http://www.american-appliance.com/catalog/newsdesk_info.php?newsdesk_id=136 to remove the whole agitator check out the instructions as follows: (1) Kenmore washer..... Remove the agitator cap,

...the upper part of the agitator not expensive and not hard to do ,,,, pop the cap off the upper agitator remove the 7/16 bolt and lift off the upper part and replace the plastic dog ears and

...plastic that holds the "dog ears". These dog ears are what lets the agitator move in one direction and locks when the transmission moves back in the other direction. Maytag and Admiral washers are ...

...the agitator and un screwed the bolt. I grabbed that white piece out and there were four little plastic pieces that looked like dog ears and i replace them for under 1.00 and mine was fine after

plastic that holds the "dog ears". These dog ears are what lets the agitator move in one direction and locks when the transmission moves back in the other direction.Maytag and Admiral washers are

...unscrew it and pull out the top area the dog ears will be there three little plastic thing looking like teardrops with small fins to catch the agitator to move it they are worn out cheap to ...

...I have an older model washer that has "dog ears" in the agitator that allow it to work in a ratcheting motion. These plastic dog ears wear down and have to be replaced or the agitator stops