Questions & Answers for: polaris carb settings

polaris 300 xpress will not start carb seems clean and i just put new piston and rings was locked up when i got bike. but starts on starting fluid and back fires 3 inches of fire out muffler Seriously

to know the right screw turns for the air and fuel mixture and the high idling screw The polaris air screw are 1 full turn each for the 650's, used drill bits to set up the carb plunger, 1/8,,1/4. etc

...polaris,2 cycle eng.. carb wont adjust to idle position. i attempt to set while running and the rpm is about normal and then rpms auomatically go through the roof . have to shut down quick to keep ...

...Polaris 330 Trail Boss has been setting for over a year. Ran fine but now after a new plug, drained and flushed tank. new battery, oil change and filter, no gas is getting to spark plug. Checked ...

what should the finger screw on the carb of a Polaris 330 magnum be set at? The air or Fuel finger screw is out of adjustment what is the factory setting? Start at a turn and a half out.

...does my polaris not have any power new rings new timing chain and sprockets Could be a carb issue, did you set your timing correctly? Your cvt belt could be slipping. If it runs good check the

polaris.../41045-93-xlt-carb-settings.html Nov 27, 2009 - I bought a new to me 95 polaris sport last year. it had not run in twoyears. ... It's all in the tuning, clutching, jetting and gears.. i have

...Polaris sportsman 500 will run great for a couple minutes then dies. I let it set for a minute and it fires back up. I have to continue to do this as I am riding and it is very frustrating. Sounds ...

...polaris it stalls when put in reverse how to repair Hey Wayne... Does it run fine in forward? Try to eliminate anything that causes this issue in forward and reverse. Clean and set carb (by a ...

...polaris ranger 4x4 500 when i climb a pretty steep hill it dies on me like not getting fuel it takes awhile but it eventually cranks but misses and alot of times will die 3-4-5 more times Hey Wade... ...