...pull it up slowly but firmly. It should pop out with little difficulty. Keep pulling it up until you've removed the entire head from the charger, but make sure you don't pull far enough to yank out ...
...pop when i pull the inside cable latch release What can ido to open or pop the hood Have someone pull on the cable while you pull up on the hood, if that doesn't work and the cable is broken you will ...
pull handle does not pop it open, try to remove the handle slightly from the dash. This involves removing 2 phillips head screws (one from either side of the handle). When these are out, you should be
...cable looks connected at front pop the trunk there is a handle in side right near the filler cap pull handle if it pops then it is cable at 1 end or other if it doesnt pop then it is likely a ...
...pop the hood. any ideas how to get the hood open ?? im going crazy.. it seems that the good opens from the window side up. have someone pull the latch while you press down , then lift on the hood. ...
...The hood even though it sounded like it "shut" it didnt! push firmly down on the hood you may or may not hear a click or pop. tyhen try the ring wire pull then the right up lever it should
...pop up waste won't close When you pull out the stopper is it completely intact? there should be a hole at the bottom of the stopper were a rod goes through. That moves on an axis pulling and pushing ...
...pull cord kit that has great instructions. My mower, however, had pop rivets holding the cover on the engine, so if yours does too, get a pop rivet tool with the correct size pop rivets before you ...
Question about 22" Yard Machine Push Mower
...pull cord to see if it is bolted on or pop riveted. If it's pop riveted you'll have to drill out the rivets to get at the cord. Have a pop rivet tool and the proper sized rivets ready to re install ...
Question about 22" Yard Machine Push Mower
...that works the drain. There's usually a nut that the lever goes through on the back of the drain pipe that engages the popup. Loosen the nut, pull back on the lever, and that will release the
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions