Questions & Answers for: power button front ge dryer

...power button which wouldn't work either. I unplugged the dryer and plugged it back in, and it let me press the power button on it again, but still wouldn't start. I'm at a loss as to what to do now!! ...

...power button on my dryer it won't start. When I set the time the element starts to heat but it doesn't spin. I hear no sounds other than the normal sound of the timer turning. When I push the power ...

...power button, the control panel lights up. When we push start button, it does not start and control panel turns off. If we push power button again, it lights up and then goes out. After unpluging and ...

button did not open the door. I pulled the electrical cord to stop the power. I then replaced the plug and turned the power back on but only got the same hum with the same display and still cannot get

power but the start button isn't working it may be the the door switch or you can try resetting the motor: 1) unplug dryer 2) put dryer on its front side 3) lift up the bottom of the dryer(so that you

...power to the dryer to check other causes. Your door switch could be open, not completing the circuit. This can be checked by a resitance/OHM test. Your Thermal Fuse could be open which is usually ...

power button is loose The power button ended up getting pushed in and is loose. The power will not turn on. Gfdn240elww Power Button Repair1. Remove selector knob by pulling perpendicular to the panel

power button broke gfdn240el1ww There are two main pieces to the front panel for the GFDN240EL1WW dryer-- the plastic panel and the circuit board. The actual replacement part is: Control Panel ...

power button stuck will not stay pushed in but does work why? Sounds like simply the mechanical aspect of it has failed somewhere. Get your complete model # and enter it into the search box at ...

...button is pushed and drum will not turn. The power is turned on and when I push the start button it clicks and does nothing else. The front display works fine. Thank you in advance! If the motor runs ...