Questions & Answers for: Buick LeSabre no power from ignition

Question about 1993 LeSabre

1 Answer

...power then your ignition switch or a lecttrical problem is present, also make sure to do a cotinuity test to the wires coming from crank sensor to ignition module, check them for open or short to ...

Ad

Question about 1998 LeSabre

2 Answers

...the starter it runs great for 10 seconds and dies. there is something wrong with the ignition primary circut (all the power supply to the ignition.) or there is just no power to the ignition ...

Ad

Question about 1997 LeSabre

3 Answers

...power on the ignition wire while again trying to crank the engine. If there is no power the easiest thing to check is the ignition fuse. If the ignition fuse is okay then you have an open circuit ...

...power then may have a bad ignition swith the antitheft sensors in ignition are bad to read the chip in your key or the wiring to the ignition for the sensor has a break and ignition replacement is ...

Question about 2000 LeSabre

1 Answer

...There are 3 distinct circuits running from the ignition switch, it sounds like one of them are faulty and not allowing power to certain circuits. Best to have it diagnosed at a reliable auto

...power to one of the ignition coil packs You have 3 individaul coils each one sits on the ICM(ignition control module). Now if there is no power to one of the ignition coil pack youll have to replace ...

Question about 2001 LeSabre

1 Answer

...isnt illuminated. No radio, power windows, locks, or chime when key is left in ignition. Fuel pump doesnt sound like its coming on. No blown fuses. Did you check the ignition switch? It can be

...ignition and I was able to get power for the radio to turn on. I returned to the dealership, they re-keyed a new key for me since we noticed a difference in the cut. I bring the key home and the ...

ignition switch but would that cause no power through out the car? no dash lights, headlights, nothing except a the little red security light on radio The fact that you can turn the engine but not get

...Power 2 Install a scan tool. Close all of the doors. Turn ON the ignition, with the engine OFF. Wait 5 seconds, then turn OFF the ignition. Wait 10 minutes. Observe the dash integration module (DIM) ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

1998 Buick LeSabre
1998 Buick LeSabre

897 Questions

Manuals & User Guides

Loading...