Questions & Answers for: Mercedes-Benz 300-Class no power from ignition

Question about 1985 300

1 Answer

ignition and the power light turns on, but when you turn the key the car won't turn on. This is a bad problem, and will probably require you to replace the entire ignition system and wiring located in

Ad

Question about 1985 300

1 Answer

...you a good idea which ones need to come out first. usually the top ones. The fan sits inside, so make sure theres no power to fan, or ignition, as it will cause you to have a very bad and bloody

Ad

ignition switch on the car the power goes out. when i try to start it again there is no power at all. It sits for a while and the power comes back on but it only repeats the cycle. HELP??!!!!??? Stuck

...power loss and get the benz running. Thanks, Vincent with the milage you have on the vehicle the alternater brushes are most likely worn out. It sounds like you have several different problems. I ...

Question about 1988 300

1 Answer

...is no power on plg terminals. Where do I start ? hi first,fuse for ignition system was ok,clean your distributor cap and rotor,check connection on electronic switching unit,maybe your ignition ...

Question about 1993 Mercedes Benz 300 Class

1 Answer

...power to the fuels pumps. So,we hooked a jumper wire from the battery to the fuel pumps and they started running but car still did not start, it just cranked over and over, it act like it is not ...

on my 1991 mercedes benz 300e(not diesel) the car starts fine but when i let go of the key the car stalls Ignition switch may be going out not suppling power when released.

...there should be battery voltage on the big wires. The small wire is the starter solenoid. Front the junction block, the power goes to the light switch then to the ignition switch. Good Luck ...

...power wires at the ignition switch for a short. It sounds like something is probably staying on when it shouldn't be.Has the alarm been acting like you said for very long?We may have to go backand ...

...ignition switch is activated there is no power to the neutral safety switch. Power to the neutral safety switch comes from the ignition switch on the violet wire. If there is no power at the violet ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...