...light being solid red: 1. Media is out. Reload a new supply. Press feed button to continue. 2. Power-up failure. Switch power OFF then back ON. 3. Printer ready to receive flash programming during ...
...power back on. When light starts to flash, release finger from feed key. When light starts to flash again, press and hold the feed key until the light turns red (or amber), then release finger from ...
...- ribbon breaks between the yellow and magenta when printing solid blue background. Pls sent ribbon 200 YMCKO i serie prices to me in this volume 10,50 and 100 rolls . Thank you Tanny ...
Question about 110Xi III Plus Thermal Printer
...light to off by pressing pause once? If you can, be ready to have someone come and look at it anyway. The printer may need a professional. Hello, What happens when you power off and power back on the ...
...model TLP2844-Z has a green light blinking even when the printer is not connected to the nework cable. It will blink when there is power. It will go solid once there is a network connection
Question about TLP 2844-Z Thermal Label Printer
...light will come solid green. Serial connections are very slow, you can do the upgrade via the Parallel port which is faster. I would not use the Ethernet port. If the upload is interrupted you could ...
...light on in the back and will not print or register on PC for printing. Had a pop up that said "USB hub power surge" but then went away. Tried different power strips and plugs and same thing keeps ...
...power light is green and solid the error light is blinking the check ribbon light is on solid and the pause light is on solid The printer thinks it is out of ribbon. If the condition exists and there ...
...light Solid red light when turned on and nothing else happens. I've held down while powering off and on. I've stuck a paper clip in the reset hole. Nothing happens. Try driver from ...
light to turn solid red, and then release the feed button. The status light will blink green a few times, and then turn solid green. Press and release the feed button once. The status light will blink
Usually answered in minutes!
402 Questions
235 Questions
259 Questions
211 Questions
195 Questions