Questions & Answers for: power supply 15 volt

power supply gigaset 8825 Can you give me technical data of power supply: Type of electricity: alternate or current- voltage- etc thank you The power supply for the 8825 base is to be 13 volts AC, ...

watt size and supplies two voltages... one that feeds a +/- 15 volt three terminal regulators... Probably 22 volts +/- to the regualtors and the other supply will be unregulated to the power amp chips

...or any Watts is the amount of draw from the unit-not the power supplied to it- Watts= Volts(supplied)/Amps(being used) if you only want to supply 15 watts then reduce the amps (with a fuse) to ...

power supplies and the +/- 85 volt supplies are producing. Next check the +/- 15 volt regulators. You will likely find one or more of these supplies are defective. Cause could be blown parts or cracks

...power supply problem. We need to find if the power supply is putting out what it is supposed to. Using a meter, put one probe in pin 1 (ground) of one of the mic connectors, say channel1. Put the ...

VA voltages from the power supply to the Y main and the Z sustain modules. If they are present then check for 5 volts and 15 volts to turn the modules on. Those can be found on the power supply module

power supply has likely failed. Take it in for repair or repair yourself. The power supply is VERY simple. Here is a schematic close to your unit: http://elektrotanya.com/dbx_3231l_eq_sch.pdf/download

power supply, my problem is that it takes 7-20 minutes to turn on after we plug in the power cord..led power indicator no lights. The E-8 mixer lights the power LED from the +15 volt regulated power..

...power supply board with no change. When I turn on the TV the relay clicks and the led on front panel blinks 6 times and goes out. If I use the remote, it blinks rapidly. I checked the top led on the ...

...mode 1: speaker wires 2: Faulty power supply and usually this is the problem. there is an internal power supply for +15 and -15 volts regulators. on the main board . need to be replaced Good ...