Questions & Answers for: Renault R5 problems with renault kangoo

Question about Renault R5

1 Answer

kangoo rxe 1.4 auto. the fan for the cooling system is not operating at all and causes overheat when stationary. any ideas on where to start checking why ? thank you called the rac and the man spent ...

Ad

Question about 2006 R5

2 Answers

renault kangoo electrics loss of clock and trip mileage when starting from cold renault electrics ,,,,dealer only normally, any attempt to play will cause immobiliser to cut in.Be prepared to lay the ...

Ad

What is the hose called that goes from the engine block to the water pump and radiator on a Kangoo 1.9 diesel. I don't work on those but if it's a relatively short, pre-formed hose,in the location you

in my car renault megane i forgot the code for the cd reader which is also for the air condition, Please advice me how can i solve this problem The code is sometimes written in the manual for the ...

renault megane 2006 model, tailgate boot lock is not opening, how do i resolve this Hi, had exactly the same problem, turned out to be broken wiring in the connection snake..did I full write up on the

renault kangoo horn stopped working,fuse is ok.any help is good. van is 1999 D 1.9 hi check the terminal connections at the horn attach test light to one and hold prob to other get assistance to press

Question about 2006 R5

1 Answer

Hello, i got a messege on control panel that key card battery needs changing, this i did with new batterys ever since its been a nightmare very hit and miss as to it working at all, im worried me and ...

...problems still happening. Renault Clio what year is this clio ,sounds about right for a renault of around 10 yrs old ,keep key away from mobile phone and TV screen and if its an older model with a ...

renalt kangoo van 2009 how do you reset Service reset: 1. Press and hold the reset button [A]. See the picture below. 2. Keep the reset button [A] pressed for 10 seconds. 3. The new service interval ...

...renault kangoo 1.4 my alldat book says 20nm and then 240º with new bolts,what a load of rubbish ,clean the bolt holes out and make sure no water or oil down them ,do in sequence and tight first ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...