Question about Endura 30 Freshwater Transom Mount Trolling Motor
prop shaft) holding the prop, or you have damaged the slot on the prop that the pin sits in. Prop is secured to the shaft with a metal nut, or flat plastic wing nut. Remove the nut to remove the prop.
Question about Endura 30 Freshwater Transom Mount Trolling Motor
...prop-shaft and the gearbox. THe front of the prop-shaft slides over the splines on the end of the gearbox and the end of the shaft bolts onto the flange on the differential which locates the ...
Question about Endura 30 Freshwater Transom Mount Trolling Motor
shear when under too much pressure so that you don't damage the motor, shaft or prop if the prop hits something that doesn't give. If you can turn the prop freely then this may be your problem
...Prop shaft bearing on freelander needs replacing again. Why? Prop shafts are actually balanced, if the balance weight has fallen off it will keep damaging the bearing, check for a balance weight, it ...
...prop from shaft , prop is stuck Once You Have Removed The Nut And Lock Washer , Then You Will Have To Get A Puller To Pull It Off ,Or Lever It Off, There Is No Other Way It Has Probably Coroded And ...
...ON THE PROP(SHAFT AND BEARING DAMAGE) SOMETIMES THE PROP HAS TO BE CUT OFF...REQUIRING A NEW PROP! TIP: IF THIS IS THE CASE:*** ALWAYS COAT PROP SHAFT WITH ANTI-SEIZE COMPOUND WHEN INSTALL A
Question about Riptide St Saltwater 55 Bow Mount Trolling Motor
...prop the shaft will spin normally but the prop is now no longer held to the shaft correctly hence your problem. Check it by marking the prop and shaft with a straight line then put it in the water, ...
...prop shaft located? I asked about my periodic cruise control and received an answer saying that it sounded like the sensor on the prop shaft was loose or defective. Your vehicle doesn't have a PROP ...
Question about 2004 LeSabre
...shaft is not bent as the leg and skeg is longer than the prop, and damage from submerged collision will result in motor mount rubber damage beside prop blade damage There is possible bearing/gear ...
Question about 2004 LeSabre
...through the prop and shaft. Remove those to get the prop off. It may have been on so long, there might be rust and other junk holding it on. Spray with penetrating oil and let sit to loosen the
Usually answered in minutes!
413 Questions
78 Questions