Questions & Answers for: Chevrolet how much psi should be in ac

...PSI Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM’s – Ranges from 25-35 PSI Normal high side reading ranges from 200-350 PSI Don’t assume that if adding little ...

...PSI Normal low side reading with AC on high speed and MAX & engine at 800-1000 RPM?s ? Ranges from 25-35 PSI ? Normal high side reading ranges from 200-350 PSI Don?t assume that if adding little ...

...psi at idle. If this doesn't correct the condition, the compressor may be worn. It is common for ac to get aa little warm when sitting still, however if it is really warm then you have a real ...

...ac/compressor/a new will last 15 min to an hour or blow right away. can you give me a place to start looking. i dont think the fuse feeds anything but the relay CHECK THE PSI IN THE SYSTEM IF ITS ...

...LIKELY NEED MORE REFRIGERANT IN SYSTEM SOUND LOW FIRST HOOK A MANIFOLD GAUGE SET CHECK AC LOW PRESSURE SIDE AND HIGH PRESSURE SIDE.LOW PRESSURE SIDE SHOULD BE 34 PSI AND HIGH SIDE SHOULD BE 228

...AC pressures supposed to be on a 2000 Monte Carlo? On hot day @ 85=+ degrees it should be between 45 to 50 pounds on the low side pressure port The low-pressure gauge will read between 30 psi and 35 ...

PSI. DONT PUT ANY REFRIGERANT IN AC SYSTEM IF SYSTEM NOT LOW.PROBLEM COULD BE ELSE WHERE COULD HAVE MOISTURE IN THE AC SYSTEM. CONDENSOR COULD BE OVERHEATING COOLING FAN NOT RUNNING OR AC AIR DOOR NOT

...cooling I Already change the expansion valve and the problem continue, the low pressure is 80psi and the hight is 190 psi. what high pressure AC aveo car Sounds like you have a worn out AC

ac recharge kit, and when my vehicle was off the lo service line read 170 psi so I didn't add any fluid when I started my vehicle the psi went down to 100 and was only blowing hot air, so I still didn

... as 350 psi is really high Gm ac systems are pretty efficient unless they are worked on by any one other than accredited ac specialist shops I suggest that you visit one to get to the base of the ...