Just pulled the head for repairs and re-installed it back in the car. Hooked everything back up. Connected the negative terminal to the battery and then the positive terminal. When the positive ...
starter rope will not pull. Will pull smoothly Chainsaw starter rope will not pull. Will pull smoothly with spark plug removed. when taken off the rope pulls freely. If I understand what you are ...
...pull starter problem hard pull; have changed fuel filter; pull starter works with spark plug out, but still hard on the odd pull with starter in? Many modern saws have sufficient compression to ...
Question about 1981 GL 1100 Innerstate Gold Wing
...pull out the starter the small gear may drop into the bottom of the motor and hang by the chain. I have talked to customers that said they pulled the starter out and the gear stayed in place long ...
Saw starter pulling too hard to start. Starter pulls so hard I can't hold saw down with my foot and will rip starter cord from my hand. This saw does not have a decompression valve. Remove ...
...pull starter to connect to the engine where does the pull starter rope connect to the motor The pull starter connects to the recoil starter which sits on top of the engine. When the string breaks, it ...
...starter motor solenoid relay switch (11450) consists of a pull-in coil, a contact disc, and two terminal contacts. Battery voltage is always present at the relay positive terminal. When the ignition ...
...starter. Pull the starter, remove the four bolt at the back of it. Pull the cap off the starter. remove the clip on the end and pull the bendix out.. Just a note.. they quit selling bendix and ...
Question about 1998 Ranger
...Over pulling or quick "yanks" on the starter rope can deform the spring. Best tactic, pull lightly until the starter pawls engage, then briskly pull the starter rope. Im havung same problem any ...
Question about 1998 Ranger
...Pull Cord: Flip the starter cover over and replace the pull cord. Make sure it's securely attached to the pulley. Reassemble the Starter Assembly: Put the starter assembly cover back in place and ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions