...pump it takes to start a 2001 chevrolet malibu 3100 engine i believe it's around 80, but anything higher than 60 should run it somewhat, just lacking power, and dogging out while accelerating, like a ...
Question about 2003 Sierra 1500
filter, and check that the oil lines from pump are not obstructed, if there is nothing in there then replace oil pump. If instead the gauge reads 80 with engine off, that is a defective pressure gauge
PUMP PRESSURE IS 60PSI ON COLD DAYS AND RUNS GREAT 4.3L It could also be caused by the fuel pump relay. They're cheap and I would start there. There could also be a heat sensitive sensor. Did you scan
...runs good I am almost sure what you have is only a single pump and should only rut out 125 psi tops. you should not exceed this with a pump of that type. If it is a 2 stage pump (one large and one ...
Question about C6110 150 PSI 25 Gal OilFree Induction Vertical Portable Compressor
80 PSI AND THE REGULATED PRESSURE SITS AT ABOUT 70 PSI,IT DOES NOT GO ANY HIGHER, IS THIS NORMAL AND IF NOT WHAT DO I LOOK FOR TO GET BETTER PRESSURE. WHEN THE COMPRESSOR IS RUNNING IT NEVER KICKS OUT
Question about C2002-WKR 150 PSI, 6 Gal. Oil-Free Compressor w/13 Piece Hose & Accessory Kit
...80 gal 6hp air compressor and the safety valve on top of the pump lets air out before the tank reaches its correct psi. The pressure switch is set to 175, however the safety valve activates at about ...
...pump is working i hear it kick on when i turn key if it is fuel injected that truck needs in the range of 70-80 psi to run had one with 45psi that would not run so make sure it's putting out enough ...
...80 miles and started messing up I found rust in the tank and cleaned it and thr fuel filter I also saw that it has a fuel pump can it be cleaned and how much psi am I suposed to have The fuel pump ...
80 psi warmed up and about 60 psi at idle still persist. They now are saying that this is normal with new pump. My question is this normal and will i do damage running it at that pressure. I am sure i
Question about 1999 K1500
...Pump is running at 85 psi key on. when started will pulse between 80 and 90 psi. Any thoughts as to why it does not run at 38 - 42 psi as manual says it should. Very hard start. Dies when you put in ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions