...caliper. the old pads should just fall out. remove the master cylinder cap. (the jug with brake fluid in it.) compress the piston replace the old pads and push the claiper back down on the rotor. ...
...push the piston back in Bucket to set the caliper on while changing the pads On the rear brakes I had to borrow the special tool to push in rear disc brakes from AutoZone, this tool spins the piston ...
...caliper out and the piston was all the way out, i noticed it's bolted on but I can screw it back on; do i go counter or clock wise, is do I have to pressure it ehile I do this?, can you please help ...
...piston in a little, then turn it a little bit, and repeat. There is special tool to screw back the caliper.s piston.The tool turn and push on one time.This is because your hand brake is on a
Push piston back into brake caliper housing. 8. Install inner brake pad (with expanding spring) in brake caliper piston. (Arrow marked on pad - if exist, must point in direction of brake disc rotation
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions