Questions & Answers for: put muffler

muffler clamp,2 hanger bolt,2 nut( 10 mm). next. put small dab of grease on exhaust donut gaskets so they will stay in place by themselves when you stick them in place in the exhaust ports ,on the cyl

...muffler and put a full tank of gas. But after a few minutes it loses power almost stalls. the fuel mix is 50:1 I think it should be 32:1 for homelites. I tried taking apart the muffler tightening it ...

...put noise coming from under the hood- took to muffler guy, not the muffler most likely (since it is not the muffler) is the donut where the ezhaust pipe hooks onto the exaust manifold....or the ...

...of the muffler is fine, only the actual muffler and the one pipe going into it. Thanks. you just need to cut the pipe behind the muffler and expand the new pipe and put a pipe clamp and it will be ...

...muffler? Easiest way to find out is to put the car on jacks or ramps. Then roll under and examine your exhaust system. It could be your muffler, exhaust pipe, or catalyic converter. More than likely ...

...muffler was put on 9/12 Is engine running OK? If so and the muffler is an economy muffler, take it back to where you had it installed and see what they will do for you. If the engine IS NOT running ...

muffler and put it on - they are ALL the same. Buell never changed the exhaust on the blast at all. If it is aftermarket(vance and hines) than you need to measure the pipe and find something that fits

it be the coil? Did you put a new muffler bearing on it? Pretty sure you seized the muffler bearing by opening up the throttle without the ferndocker engaged. That always seizes up the muffler bearing

...muffler, I didn't put the heat shield between the muffler and carburator back on. The added heat from the muffler was vaporizing the gas in the carburator where the engine would no longer run once it ...

...put a new muffler/glasspack in for performance reasons or will it not make a diffrence if i put a muffler in or just a straight peice of pipe? I dont have the money to redo my who system so i want to ...