...PVC joint plugs into that may be clogged. Car will run with out plug in. Thanks, Chris change fuel filter replace spark plugs and wires.if that dont help check fuel pump pressure it should be 41 -47 ...
Question about SAND FILTER, PRO SERIES
...filter off) and put PVC cement on the outside of the drain thhreads and a bit on the inside of the valve and screw it on. When the glue dries(5 minutes), you now have a drain that you can open and ...
...filter) to the one that goes to your valve cover. Your pvc valve will be at the end of the hose. pvc valve can be tested by pulling it out of the valve cover while still attached to the hose. Start ...
...pvc valve and gasoline filter 2000 mercury marquis Gasoline filter would most likely be underneath the driver side rear of the vehicle. Follow fuel lines from the tank, and it will lead you straight ...
...air filter? Sometimes a dirty air filter will make it pull up oil if it can't pull in air. The other thing to check would be the PVC valve. PVC valves are cheap and I would just replace
Question about SAND FILTER, PRO SERIES
...pvc pipe on a hayward sand filter if the centre pipe can be matched to a pvc pipe size then the next problem to consider is the hole size or slots to allow the water in or out of the tube filtration ...
Question about SAND FILTER, PRO SERIES
...PVC plumbing. Could that be the problem because I didn't add DE to the filter yet. if you only have a skimmer and no valve to direct suction from the skimmer to he main drain, you will nee to ...
...filter on my equinox I noticed that there was an oil residue on it. Can you help me understand what is going wrong and what needs to be replaced so this does not continue? pvc valve in valve cover is ...
Question about Clean and Clear Cartridge Filter System Size / Power: 100 sq. ft / 1 HP Pump, 100 GPM
...filter was installed with 2" PVC but the pump has 1.5 inch input and output. I'm wondering if there is any reason it should require 2" PVC or is 1.5 PVC ok for install? You may experience a little ...
problems,dirty fuel filter,dirty MAF sensor,vacuum leak,exhaust leak,oxygen sensors.PVC valve open.Put good fuel cleaner to tank change air filter and fuel,Clean MAF sensor.Replace PVC valve.Any codes
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions