Questions & Answers for: Maytag r11

Maytag Neptune m/n MAH3000AWW burnt R11 resistor My washing machine control board has a burnt resistor labelled R11. Do you know rhe value of this resistor? STOP There is a short in the door lock ...

...washer I ordered a wax motor but I am not surewhat do I do about the burned circuit board at r11? It is true it lookes like a tiny burn at r11. Thank you for your help! The R11 burns because ...

Door won't lock. R11 on Household Machine Control board is blown. WOuld like to know the value of R11 for component replacement. don't waste your time been there done that other componets are damaged

...after wash cycle is completed. Maytag MAH4000 does not going to spin cycle. After I replaced Q6 and R11 (R11 is completly burned beyond recoznition ,replaced with 10.30K ohm ). Now the machine going ...

Maytag Neptune MAH4000AWW What is the resistor R11 (ohms,watts & tolerance) on the control board? Also, Q6 I would like to replace. What is this transistor? I need to know the value of the R11 ...

...which I need to replace. I own a Maytag front loader washer, model no. MAH4000AWW. Resister no. R11 which is located on the "household machine control board" [Maytag's name for this control

Washer does not drain. Checked r11 resistor I have a maytag Neptune mah3000waa and Found my r11 resistor is burnt up. I was wondering what the replacement resistor is and what causes this to happen. ...

...common issue with these is the door lock assy. You need to remove the control panel and check the R11 resistor on the board most likely it will be burnt. This was a common issue a few years back.

...What you need to do is, take back off were timer is, check and see if resistor is burnt out R11. If R11 is Burnt you will need to replace

...that is controlled by a low control voltage, which is provided ultimately by the processor U1. The R11 overheats because the failed Q6 is allowing 120 volts on the triac's center control pin. When ...