Question about Parts Cash Register PC Desktop
Casio pcr-202 reading all zeros and buttons arent doing anything i just got a Casio pcr-202 and the display is reading all zeros and buttons arent doing anything. tryed to reset from directions on ...
...read zero at normal cruising revolutions. Too much main bearing clearance or a weak oil pump would be my first guess. If you have 15 to 30 psi(pounds per square inch) at start up and it drops down ...
...read zero. If zero replace Battery. If reading is higher, start by removing the fuses one at a time until the meter reads zero, this will be the circuit causing the draw. Re-install fuse and unplug ...
...zero switch should read near 0 ohms. While the ohm meter is still connected to the zero switch, activate the switch by hand and the reading should change to infinite (open). If either reading is ...
Question about Efx 546 Version 1 Lower Body Elliptical Crosstrainer, 110v
...zero switch should read very near 0 ohms. While measuring the zero switchwith the ohmmeter, activate the switch by hand, the reading should change to infinite (open).If either of the above readings ...
Question about Efx 546 Version 1 Lower Body Elliptical Crosstrainer, 110v
...check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or infinity. Turn the switch, and the reading should change from zero to ...
Question about Tumble Dryer Heater/Thermostat (2957500600)
...zero, the coil is bad. Timer could be bad -- Disconnect the leads from the motor. Set the VOM to RX100. Clip the probes onto the leads. If the reading is infinity, the timer motor is bad. Read more: ...
...zero, the coil is bad. Timer could be bad -- Disconnect the leads from the motor. Set the VOM to RX100. Clip the probes onto the leads. If the reading is infinity, the timer motor is bad. Read more: ...
Question about Tumble Dryer Heater/Thermostat (2957500600)
...to each other. If you read anything significantly higher than zero across the thermal fuse, replace the thermal fuse with an identical one - same part number, or same current/temperature
...and write the numbers down for each one, you will probably find at least one of them with a zero reading. Then squirt oil in each cylinder and test again. If the pressure tncreases over the first ...
Usually answered in minutes!
2,522 Questions
276 Questions
209 Questions
172 Questions
114 Questions