Questions & Answers for: rear axles

...axles. Install fill plug and tighten to 20-41 Nm (15-30 lb-ft). Install rear brake anti-lock sensor indicator . Tighten retaining bolt to 4.5-6.8 Nm (40-60 lb-in). Install rear disc brake caliper and ...

1994 gmc rear axle removal how to 1994 gmc rear axle removal to fix wheel bearing -Remove tire and brake drum -put drain pan under axle housing -remove rear axle housing cover (10 or 12 bolts) -turn ...

replace broken rear coil spring on pontiac montana PLEASE DON'T FORGET TO RATE!!! Removal & Installation Remove or disconnect the following: Brake hose bracket screw from the control arm Shock ...

...remove gears from differential on a 95 mustang v6 Removal Raise vehicle and place jackstands under rear frame crossmember. Lower the hoist so that rear axle housing is at suitable working height. ...

...rear end in a 2000 gmc yukon and how to remove axles Removal & InstallationTo Remove: Before servicing the vehicle refer to the precautions at the beginning of this section Loosen the lug nuts on ...

1998 ford explorer 2 wheel drive rear wheel bearing replacement what about it? conventional axle or limited slip? Get axle code off door sticker. SECTION 205-02: Rear Drive Axle/Differential - Ford ...

Rear Axle Housing Cover and Gasket Replacement. Remove the pinion shaft locking bolt. On axles without a locking differential, remove the pinion shaft. On axles with a locking differential, remove the

Replace REAR wheel bearings 2008 F250 super duty 4wd Need tutorial on replacing the rear wheel bearings in my 2008 Ford truck 4x4. I found info on the front, but it's the back I need help with. ...

...Cherokee Sport (XJ), there are typically two speed sensors: the vehicle speed sensor (VSS) and the rear axle speed sensor. The VSS is located on the transmission or transfer case, while the rear

Rear axle torque specs on 1993 sportster hugger In my day, torque wrenches were only used for cylinder heads. Rear axle nut with just done 'tight' with a socket set ratchet. Rear axle torque specs ...