...rear pinion seal.I can install the new seal but need toknow how tight to replace the pinion nut. check your rear diff vent if pluged clean it out and clean up the pinion seal.sometimes if the leak is ...
rear pinion on f350 depends on rear axle you have Dana 80 pinion nut torque is 470 ft lb pionion brg pre load is 25-45 in lb Dana S110 pinion nut torque is 832 ft lb pinion brg pre load is 20-40 in lb
...pinion seal int he rear of this car? Also, could I possibly need the crush sleeve replaced? The car shifts okay.....Thanks this is for 2003 7.5 inch ring gear axle. SECTION 205-02A: Rear Drive ...
Question about 1994 Firebird
...rear end!!! This is a Pinion Baring - it needs to be replaced. This is not an easy job - you need to know what you are doing. Remove the rear differential cover; remove the ring gear and carrier ...
...Rear End Problem Had Pinion seal replace and universals. After 400 miles has bearing sound in rear. Took it in and it was found that pinion nut was too tight. Shop replaced pinion bearings, spider ...
---- Click this link below and follow the detailed procedure:---- http://technoanswers.blogspot.com/2011/07/how-to-remove-rear-end-crown-and-pinion.html -------------- This should help.Thanks.Helpmech
...rear pinion seal on 2007 grand gherokee This is not really a job for a novice. You will have to remove the rear drive shaft from the pinion, remove the pinion nut and the pinion itself, then remove ...
Question about 2007 Grand Cherokee
...rear pinion seal, it isn't too bad at all. You just have to drop the drive shaft, remove the pinion nut and pull the pinion, then knock out the old seal and hammer in the new one. Going back together ...
Question about 2007 Grand Cherokee
...rear pinion shaft on a 2019 Ford F-150 Replaced bearings on pinion shaft. Using same shims, shaft has a crush sleeve, how how is the inch lb setting reached and then final torque on pinion shaft nut ...
rear cover. Remove the retaining bolt from the pinion yoke, and use a puller to remove the yoke from the pinion shaft. Use a suitable tool to remove the pinion nut and washer. Mark the location of the
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions