Question about 2000 FLHT Electra Glide Standard
...seat that the ball sits in. Remove this ball and install the other new ball, spring, and threaded plug. Refill the oil tank. Then, remove the crankcase breather line from the rear of the air cleaner. ...
Question about 2001 FLHT Electra Glide Standard
seat, air cleaner assembly and two rear fuel tank mounting bolts. 2. Loosen front fuel tank mount, then raise and support rear of tank. 3. Standing on the left side of the motorcycle, remove the two 8
install help driver seat back remove seat the back rest mount will bolt to fender w rear passinger grabrail mounts 1/2 in nuts 2 of them,, mount there..
Question about 2002 FLHT Electra Glide Standard
...rear of the seat screwed into the fender. Take the bolt out and pull the seat to the rear. If there is a "hand hold strap" over the seat, once you pull the seat to the rear releasing the tap in the ...
...the seat? Look underneath on either side of the seat and you'll see a bolt screwed up into the seat pan. Take these two bolts out, lift the back of the seat, and pull to the rear. Good Luck ...
rear seat bolt, you have to push forward and lift up after you remove the bolt. If you have a pillion pad or passenger seat that snugs up against the front seat there can be a bolt securing the two to
...seat and connect it to the existing rear lighting connector. If it is not fully wired you may have to purchase necessary harness extension(s) and connector pieces from a Harley Dealer. Of course you ...
Usually answered in minutes!
92 Questions
83 Questions
76 Questions
62 Questions
10 Questions