Questions & Answers for: rear tail lights wont turn

...Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have ...

...rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, ...

rear tail lights (the black rectangle-ish assembly on the back of your tail lights that the bulbs go into. The rear rails got fryed from getting too hot (also had LED rear lights that did same thing).

...rear tail lights. The center brake light in the rear window is not affected. When you take foot off brakes rear tail lights come back on. Most likely a bad earth to the light's. Re-earth the tail ...

...rear stop and tail light? how to replace right rear stop and tail light on 2002 X-type Jaguar? Should have acsess to lightbulbs in trunk of car. Open trunk and remove any carpet or cover around light ...

tail/brake lights wont blink or flash. 3rd brake light works fine no problem there. replaced bulbs, one of them was burnt and looked black (rear driver side) now all lights work. checked fuses and all

...rear tail light. brake and turn are the same filament in the bulb.  Try a new bulb.  if that doesn't work your going to chase a short/ground on that wire back to the switch. ...

...Rear Tail light wiring diagram for 2000 Isuzu Rodeo? http://technoanswers.blogspot.in/2012/02/rear-tail-light-wiring-diagram-for-2000.html ------------ 1997 Nissan Sentra Tail light wiring diagram? ...

tail lights not working but brake lights are pass light wont work either rear bulbs have 2 elements, has 1 element gone, does front park light work. does tail light work if ignition turned to park.

...rear turn signal light wont blink, when blinkers are on the tail light and the license plate light blink but not the actual blinker. Sounds like a ground circuit problem, or something in the socket ...