Questions & Answers for: Suzuki rear wheels turn driveshaft 2005

rear driveshaft. The swing-arm might be bent a little throwing the wheel around, or the wheel itself may be warped, take it to a workshop that has the right tools to check motorcycle wheel balance and

...the rear wheel on my 1999 suzuki grand vitara approx. 3 inches before the driveshaft moves. is there an adjustment for the ring and pinion if i pull the center section out Pinion shimming is ...

HAS A SHAFT INSTEAD OF A CHAIN. thr rear wheel is removed as normal except u will have to tilt the bike over on the opposite side to the driveshaft. dont forget the brake rod has to be removed as well

...how to take it off bike with driveshaft raise rear wheel off ground, remove axle, spacersand rear caliper. wheel assambley will pull away from final gear case and fall free from bike. no fluid

...rear etc. since 2 wheels will be off the ground and 2 on the ground. The vehicle won't run is the reason for the need for towing. Something tells me I have to pull the rear driveshaft to do this. Any ...

...turn them on and off. The other answer is it's not a four wheel drive as this shifter is in plain veiw next to the regular shifter. Not all side hicks are four wheel drive and if it doesn't have a ...

...rear wheels or front and rear wheels depending if it is in 2hi, 4hi or 4lo. The N setting for the transfer case is used when towing the vehicle with all wheels on the ground, like people do behind a ...

...driveshaft assembly and check the splines. For the rear end of it, you will need a thin-blade screwdriver to loosen the grease seal, then a snaspring tool to remove the circlip inside.  Be ...

...Driveshaft problem , can't get it back in after we take it out when we teke the back wheel of Separate the final drive from the DS then install the DS back on the out put splines of the trans, and ...

...rear swing arm. Make sure to apply Honda Molt 60 Paste grease to all splines (especially where the driveshaft enters the drive pod (take grease seal off, lube and put new seal on.) This grease is ...