Questions & Answers for: Chevrolet 1500 rear wheels turn driveshaft 2005

turn and thats the reason the driveshaft broke. What are some reasons the why yoke won't turn? You have a problem in the diff. I cannot believe they replaced the drive shaft without further inspection

...rear end jacked up and on jack stands with both or all wheels off the ground . $ wheel drive needs all wheels to be up on alevel hard surface in a quite place. With a driver in the truck driving at ...

...chevy K1500 4X4 with a NV3500 5 speed manual. I want to use it in a 2 wheel drive truck. Can this be done and what modifications do i need to make to it? You'll need to find a tail piece for the ...

...rear wheels alternate when slipping as they should but nothing from the front wheels. First of all try checking your fuse box and make sure the 4X4 fuse is still good. If the fuse is good, move the ...

...chevy suburban k1500 and when in 4 wheel drive i hear a clicking sound from under the floor That could be a number of issues with your transmission, the u-joints on the front driveshaft, or the ...

...chevy 1500. 350 motor Your truck is equipped with RWAL or rear wheel anti-lock. This just worked on the rear brakes(duh) but the speed sensor was taken from the speedometer drive at the transmission ...

driveshaft from my 1998 chevy k1500? there is a u-joint on each end of the driveshaft & i have removed the clips from around the u-joint but the driveshaft is too tight to come out? will not go in

...in gear or have bad vibration to it . it can be pion bearing in rear-end it will do what you are saying . but check driveshaft , sometimes you can see if drive shaft has play in it move side to side

rear axel at driveshaft? To replace pinon bearing you need to pull wheels and the brake drums off next pull cover off the back of the rear end (make sure you have a drain pan under rear end) next turn

...rear shaft was locked with slight play in it, but my front driveshaft was able to freely spin by hand. Any help in where to start looking or how to fix would be greatly appreciated. I tried unhooking ...