...ground signal for crank relay from pcm.so there is no power to my starter unless i bypass to ground from wire that connect to relay check pcm with a scanner to see if crank and cam sensor are
...to bypass relay and run it to battery. Last suggestion said the fuel pump would blow up the tank. How then does the fuel pump get power? Why not just rplace the relay, or the wires to the
1994 buick park avenue . driving home and shut off i checked no fuel press jumped the pump relay and pump runs and press to manifold . batt is up . no ignition . the check lighis do not come on . ...
...the ignition switch and follow it down to the fire wall, is there a relay in line with it so jump a wire across it to bypass the relay or take it out all together and connec t the yellow wire back ...
...bypass the relay. If the car still won't start the problem is most likely in the colum, either the chip in the key or the resistor in the ign. lock. You can start the car by locating the purple wire ...
Question about 1999 LeSabre
...no brake lights. Replaced SLS still no change. ABS fuse and brake light fuse are good. Swapped ABS relay w/ Horn relay, no change. Does brake light wiring run through turn signal switch assembily? ...
Question about 1994 LeSabre
...bypass it. ive used this module before It's been a long time since I had to work on one of these VATS systems(Vehicle Anti Theft),but I believe there is a relay that can be bypassed to get around the ...
Question about 1994 LeSabre
...on 2005 Buick century will not work need to bypass light switch in turn signal relay hi or low beam's don't work ? need to bypass light switch in turn signal relay why ? Care to explain that one
Question about 1994 LeSabre
bypass the fuel enable relay on my 1995 Buick lasabre? Because you said enable relay, makes me think about security system? Voltage to your fuel pump, two ways, one is through the fuel pump relay, the
Question about 1994 LeSabre
...pump relay. The contact side of the relay is fed battery voltage via fuse F1 (under hood fuse block) You can bypass the pump relay or probe the relay control side for the presence of power and
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions