Questions & Answers for: Hyundai relay bypass

...that if its a manual that its in Neutral. If the starter motor turns then the problem is either the relay or the ignition switch.Or if its an automatic Transmission it could be the inhibitor switch . ...

...relay switch ? and if it is a switch where is it located ? thanks your A/C switch has probably gone bad so what you can do is and wire a bypass switch on dash leading to your battery so you will now ...

...bypass/disable the burgular alarm relay and alarm horn. This, however, does not disable the 'flashers' when the alarm is activated. Bypassing the relay will allow you to start the engine, but you'll ...

HAVE A 2005 SONATA CAN'T GET THE A/C COMPRESSOR TO INGAGE. CHECKED FUSES & RELAY , HAS FREON. WHAT ELSE CAN IT BE? Although it has freeon the high pressure/low pressure sensor could be out ...

...bypass it. There is a way to defeat it but again lets just short cut it, go to the engine junction box there you will see a relay listed as starter relay open the cover using a small screw driver , ...

relay is good and bulbs are good sockets for bulbs are good do you know how I would bypass the computer to get the blinkers to work without a computer hook up? Go to a junkie for the computer . A 1000

Can someone please tell me where to locate the headlight fuse relay in a 2004 Hyundai Santa fe? My headlights went out and the fuses are both good but I cannot find the relay to replace it. Things to ...

2006 Hyundai Tucson 2.7l cranks but won't start. Pulled fuel pump relay and bypassed, pump comes on now still won't start. Pulled main relay and put a jumper from terminal 30 to 87 on relay and car ...

...high pressure for the fuel injection ok now let's get this party started (1) check your fuses and relays for the fuel pump fuel injection pressure regulator fuel tank pressure sensor fuel injectors ...

...relay. It will start with no problem the next day. If your saying when the problem is ongoing, the starter motor won't crank the engine, if you'll post model year, I'll try to post wiring diagram for ...