...like the fuel pump run relay may be the problem with your car, replace it or bypass it to test, if you don't understand how a bosch relay is wired don't jump it yourself, you can burn up the
...register your car on the site and you can get this info.You are probably looking at a high beam relay or the stalk switch. If you look at the wiring diagram, the flash to pass circuit
...efi Crank but no start.....A real curly one. Fuel pump and filter replaced ran fine one week. Fuel relay suspicious was changed started and ran twice, now not being turned on by comp. Then i was ...
...Bypass the relay with a piece of wire, (preferably fused). This means: Remove the relay and put the piece of wire in place of terminal 30 and 87 in the cavity where the relay lives. Even if you don't ...
the fuse or relay. If the fuse is burned out and you don't have one to replace it, wrap the fuse with a small piece of aluminum foil to bypass the fuse and stop at your auto parts store and replace it
Question about 1992 MX-5
I have a 1993 mazda b2600i. The fuel pump randomly shuts off. Repaced fuel pump shut off relay lines cleaned tank. Once it shuts off cant even get it turn on when bypassing fuel cutoff relay. There is
...bypass the relay altogether by using a paper clip or other jumper wire to short between pin 30 and 87 or 87a on the relay connector. Pin number is located typically on the relay near the electrical ...
Question about 2004 Tribute
My car was running. I bypassed the relay for the A/C compressor to turn on the engine stopped running.Did not start again, checked for fuse, found one blown, Put fuse in, blew that fuse too. I can't ...
Question about 2004 Tribute
...bypass fp relay can hear fp but no start Hello. The ECM in your Mazda Miata may be at fault. Most ECM (Electronic Control Modules) 'shut off' power to the fuel pump when they start to malfunction; ...
Question about 2004 Tribute
bypass the switch by jump at the relay to see if I can get power to the fog lights? Most relay's have the diagram printed on them. Make sure you are getting power to the signal post to close the relay
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions