...4)Remove screw and end cover from starter. 5)Remove oil tank to provide clearance for the starter removal. 6)Remove both starter mounting bolts and washers. This includes detaching the engine
how to change handle bars HANDLEBAR REMOVAL 1. Remove maxi-fuse. REMOVAL 1. Remove left side saddlebag. 2. Gently pull side cover from frame downtubes (no tools required). 3. Depress latches on ...
remove battery from 2002 dyna The Dyna battery can be removed by: 1. Remove the seat. 2. Remove negative connection at frame, and positive connection at battery. 3. Remove the lower rear bolt. (left ...
...starter... Note: you might need to loosen the oil tank mounts to provide clearance for starter removal... Install new starter in reverse order...Torque specs... Starter mounting bolts - 13 - 30 ...
Question about 2006 FLHTCUI Ultra Classic Electra Glide
removal of an 06 ultra classic trans removal of trans gear set This removal requires some special tools and a manual. First remove the negative battery cable.Drain and remove primary cover. ...
headlight handlebar removing shroud Remove headlight trim, remove ten screws holding haedlight assembly, remove nut under nacelle, pop the ignition decal up and remove the screws holding cover, remove
Question about 2004 FXDWG - FXDWGI Dyna Wide Glide
...side cover. (If necessary, remove the allen screw and decorative chrome cover to facilitate starter removal.) THEN, if necessary remove the coupling from the starter motor output shaft, if necessary. ...
Question about 2005 FLSTC - FLSTCI Heritage Softail Classic
...Remove screw and end cover from starter. 6. Remove oil tank to provide clearance for starter removal. 7. Remove both starter mounting bolts and washers. This includes detaching the engine ...
Question about 2000 FLHTCUI Electra Glide Ultra Classic
...cover. NOTE: If necessary, remove Allen screw and decorative chrome cover to facilitate starter removal. 11. Remove the coupling from the starter motor output shaft, if
how to change steering head bearings feels like steering is trying to lock up If bearing races are removed, the bearings cannot be reused, they must be replaced. 1. Support motorcycle so front end is ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions