Questions & Answers for: Chevrolet Corvette remove base

Question about 1994 Corvette

1 Answer

...my own Corvette doing the same thing) is that it is the sway bar rubber bushings making the noise, remove them and apply white grease to the inside of the rubber bushing, then retest, it fixed mine ...

Ad

...remove the socket and bulb by turning counter clockwise. Replace the bulb. I like to put some dielectric compound or at least some vaseline on the base wires of the new bulb. Test. Reverse procedure ...

Ad

Question about 1989 Corvette

1 Answer

...remove and replace the right broken wiper arm and also replace the wiper blades on both arms? On mine I lifted up the arm,at the base where its connected to the car there is a little metal tap that ...

...by removing the ground cable first(negative). Then remove the positive cable. At the base of the battery is a hold down clamp, held in by one bolt. Remove this and the battery will lift right

...Remove the base-to-right hand rail assembly. Fig. 1: Typical fuel pressure regulator assembly - 5.7L (VIN 8) engine Twist the regulator and base assembly to the remove it from the fuel outlet tube. ...

Question about 1998 Corvette

1 Answer

...Remove all four tire and wheel assemblies. Inspect the brake system for leaks and visual damage. Inspect the battery state of charge. Install a scan tool. Turn ON the ignition, with the engine OFF. ...

...remove with the tire in place unless you turn the steering to a stop, or use a Torx bit in a wrench. Bolt securing the battery on its base facing the driver seat needs to be removed. From what I ...

Question about 1989 Corvette

2 Answers

I have a 1989 corvette when it gets to operation temp it will shuf off and will not start intill it cools off. Based on your description I suspect the ignition module is the culprit. It is common for ...

...base corvette C4 equipped with electronic air C68 system. The compressor and blower motor run when the heater and A/C Control Head blower mode is on "OFF! Air flows through Def Vents but not through ...

...the shifter gate slot might have worn out or broken. Remove the shifter base and boot and inspect the slot and tab. (the tab rides inside of the slot). An excellent replacement spring can be found

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...