Questions & Answers for: remove cable

Question about 20gb Ipod Mp3 Player With Click Wheel System

1 Answer

Cable Logic Board To remove the battery, use a flat tool to pry the battery up. It is held on with a lightadhesive, and should come up by using just a little force. Lift the battery out of the unit. -

Ad

...cable. Remove the accelerator retaining clip. Disconnect the accelerator cable. Detach the accelerator cable from the bracket. Rotate the cable to release. Detach the accelerator cable. Remove the ...

Ad

Question about iPod touch

1 Answer

Cable Logic Board To remove the battery, use a flat tool to pry the battery up. It is held on with a lightadhesive, and should come up by using just a little force. Lift the battery out of the unit. -

...cable end remove " u " clip which holds cable to bracket remove cable from release bracket working inside remove cotter pin from clevis pin on clutch pedal pull cable from engine side through rubber ...

Question about 1987 Gl 4WD

1 Answer

...Remove the cable from the hanger. Lower the vehicle. Fig. 1: The parking brake control assembly is located under the dash on the drivers side To remove the driver's side sound insulator panel, ...

Question about 1984 Accord

1 Answer

...cable guides and remove the cables from the vehicle. To install: Fit the cable loosely into place. Begin reattachment at the rear brake shoes or calipers. Make certain the cable is routed correctly ...

Question about 1984 Accord

1 Answer

...remove the cable, taking care to not damage the cable boot. On Front Wheel Drive models, remove the heat shield above the muffler and push aside. Remove the cables from the cable brackets. Should the ...

Question about 1995 F150 Styleside Regular Cab

1 Answer

...remove the cable (2) from the backing plate (4): Compress the spring (3) by pushing toward the lever (1). Depress the locking tabs. Pull the cable housing out of the backing plate (4). Remove the ...

Question about 1999 Lumina

1 Answer

...remove the cable from the accelerator pedal, push the rubber grommet at the firewall out towards the engine, and remove the cable out the engine side. Reverse procedure to attach new throttle

...cable. Remove the hazard lamps switch by gently pulling the knob straight up. Remove the instrument cluster bezel from the instrument panel. Refer to Instrument Panel Cluster Trim Plate Bezel ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...