Question about 1987 CBX 250
...all the fluids and remove the carbs and clean them replace all the filters clean the fuel tank and petcock new battery. make sure that you use motorcycle engine oil when you change it. good luck ...
...Any comments. There is a little screw near the drain pipe what is the function of this adjustment Remove the water trap bowl at the bottom of the petcock, (gas valve). Is there any water or trash
...the problem?and if so what course of action should i take,thanks turn off the fuel at the petcock, remove the fuel line from the carb, turn the fuel on, does it leak out? if not clean or replace
...remove the carbs and the float bowls to check the pins and will have to adjust the floats too . The vaccum fuel tap runs or rather allows fuel to pass by once the engine is running (thus creating ...
...remove the carbs,for cleaning,having a difficult time in reinstaling them,help,the carbs on this motorcycle were in need of a serious cleaning,i removed the carbs sometime ago,irecently had to take ...
Question about 1984 CBX 750 F
...Remove them and re-connect the sparkplug wires. Lay them atop any metal and start the bike. There should be spark on all four. Determine hw strong (color) of the sparks; verify that fuel is ...
remove the six carbs off the motorcycle for rebuild or major cleaning. where do I start its quite the job, you need to rotate the engine to access the carbs etc,make sure your carb to engine boots and
...must remove the headers and front engine mount so you can tilt the motor down to remove the carbs. Also check the timing, because after installing headers, it will change. Been there, got the
...Remove the float bowls on the left carbs then clean the carbs with spray carb cleaner. Pay special attention to the float needle. A bit of rust, gasket or other contaminant is preventing the float ...
Question about 1985 CBX
...carbs and remove the 16 float bowl screws with the carbs upside down. To remove the screws take a #2 phillips screwdriver and hammer and tap each screw with the screwdriver in place with the hammer. ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions