...cover. Remove the spark plug wires. Detach the upper part of the engine front cover out of the way. Remove the four bolts. Position the front cover to one side. Remove the valve cover. Position the ...
...cover, remove cap by tapping chain case cover using a soft hammer. Discard retainer cap and remove spring and relief valve. Remove oil pump cover screws, and lift off cover. Remove pump rotors. Wash ...
...cover in the rear. 4. Remove 2 phillips head screws in the wheel well rear lip. 5. Remove 4 pop-up plastic retainers in liftgate area. Use two screw drivers to lift the head and then pull the entire ...
...cover) remove the valve cover using both hands, and equal pressure applied by each hand. Valve Cover Gasket - Replace Installing a valve cover gasket is typical of most installations of stamped steel ...
Hold the camshaft sprocket with Special Tool 6847, or equivalent, while removing the center bolt. Remove the timing belt idler pulley. Remove the rear cover fasteners and remove the cover from engine
Question about 2006 Sierra 3500
...cover (3). Remove the lower trim cover (3). If screws are not present in the lower trim cover, proceed to the next step. Gently unsnap the lower trim cover from the upper trim cover. Important: You ...
...cover. Remove the ignition wires and spark plugs. Remove the crankcase ventilation tubes from both valve covers. Remove the retaining nuts and engine wiring from both valve covers and move aside. ...
Question about 2006 Sierra 3500
cover and remove engine air cleaner outlet tube bracket. Remove four nuts retaining RH ignition wire cover and remove cover. Disconnect ignition wires from spark plugs with a gentle twist! pull motion
...splash shield. Refer to Engine Splash Shield Replacement in Body Front End. Remove the engine balancer using the EN 46337 . Remove the timing belt cover bolts (8). Remove the timing belt cover
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions