Questions & Answers for: remove crack oil pan 2001

...remove the oil pan without the gasket because the gasket is attached to your oil pan baffle and that can't be removed until you unbolt your oil pump. i pried the **** out of mine until i realized the ...

oil, remove the starter and engine mount strut bracket. Remove the oil pan nuts and bolts Remove the oil pan and clean all the the old RTV seal on the oil pan and engine components.Installation on 2.2

...oil remove/ starter/oil lines/front wheels/-disconnect elect connector shift link housing/shift cable from differential--remove both drive axles and differential--unbolt and remove oil pan (pan bolts ...

...oil pan. I have a 2001 silverado 2500 HD and need to work on the oil pan. My question is, "Do i need to lift the engine to get the pan removed?" There is part of the truck frame that runs under the ...

...and support 2 Remove front diff assembly from chassis 3 Drain oil 4 Remove clutch or torque converter housing lower plate 5 Remove oil pan OIL PAN BOLTS 6.7 - 8.9 ft.lb OIL PRESSURE SWITCH 10 ...

...the oil pan do i have to lift the motor up or out to change the oil pan? make life a lot easier if you do, you may have to reach in and remove the pickup tube before it will allow you to remove the ...

...remove the oil pan to get to the oil pump on a 1992 chevy s10 pickup 4x4 I see where most people say pull the motor. But I was wondering if I can just drop the front axle for the four wheel drive out ...

...remove an oil pan off a 1998 ford 2 wheel drive with out pulling the engine I have a 1998 for pickup 2 wheel drive with a 4.2 six cylinder motor and I want to remove the oil pan without removing the ...

...oil. Remove or disconnect the following: Negative battery cable Oil dipstick tube Front wheels Front skidplate, if equipped Steering gear Front differential, if equipped, 4wd Lower oil pan Oil pickup ...

...oil pan removal Need to change oil pan gasket engine PAN. (there is tranny pan gasket too) no engine told at all or VIN.? 3.3L engine ? uSA? 2wd or 4wd, ??????? make sure PCV valves is not clogged ...