...other times it persists. sounds like the lvds cable has glue on it (some did) the glue has to be removed or the lvds cable ...
camera lens won't open you might of over done it with the glue,, with a Q-TIP and some acsetone or nail polish remover try to wipe the excess glue on cap and surroundings,, good luck,,,
...remove the touch screen to free the water? Can I? (I've removed everything but the screen...my son had dropped water on it) Thank you so much!!!!!! Crystal Robinson It is not possible that you can ...
Question about RM255LASH Side by Side Refrigerator
...I tried gluing into position but the fumes from the crazy glue messed up the switch and I had to replace the whole rig. The part is under the control display. You can pry it open from the left
Question about PS42S5H 42 in. HD-Ready Plasma Television
...glue become conductive over time. Check the Capacitance(unless you can see the culprit,it will look like he exploded from top or bottom) and remove any glue from the printed circuit board. Good
Question about RF265AA Bottom Freezer French Door Refrigerator
crazy glue can work wonders many times, but the correct solution is a new flap. In this case, the appliance parts house is your friend. With the model number in hand, go there and explain your problem
in front, so your remote can aim at one and not the other TV. Paper tubes will do, with elmer's glue all. Elmer's glue is water soluble, so you can remove the tube later by just wetting the paper tube
...slide switch had a crack on the piece that slides the power switch on the motherboard. Unfortunately you have to take the laptop apart to access this. A bit of crazy glue and your back in
Question about N150 (36725723009) Netbook
Can I glue a ribbon cable back to a buffer board on the 75 inch Samsung LED TV, and if yes, what glue do I use? I have part of a ribbon cable that has come loose from a buffer board inside a Samsung ...
Question about N150 (36725723009) Netbook
...crazy glue and re twist and lodge the bit in like before but this time with the glue after the glue dries u can full with a pliers gradually with increasing strength until it comes out. otherwise ...
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions