on the sender (fuel pick up pipe in the fuel tank) is getting stuck. the level sensor is a float that is attached to the sender, and you will need to remove the fuel tank to get to it. hope this helps
...no you have to remove the fuel tank I wish it did but nope sorry you have to remove the tank to access the fuel pump. Its not that hard to remove as long vas tank is as close to empty as you can
...cheap, and the fuel tank is not difficult to remove, but needs to be close to empty to make the job managable. The tank is over 3 feet long, and is better removed with 2 people if you can find
...gain access to the top of the tank to remove the sender with the attaching fuel pump on it. basicly you disconnect all lines first then the tank straps. the tank will be lighter if no fuel is in it ...
...a floor jack under the tank,remove the strap bolts, lower the tank,(just a little)disconnect the electical,lower a little more,disconnect the fuel lines, lower the tank all the way and remove
...remove the hose that is connected to your fuel filter. Its the one that's leads from your gas tank to your filter. 2.) place the end on this hose into a bottle or container 3.) turn on the ignition. ...
...will need to remove and drop the fuel tank down. Should you need further help please just ask. Please rate the quality of your answer. This way i know it was helpful. Thank You for using Fix Ya. ...
...fuel pump. Filter is not on the tank. Test it when it doesn't start, or listen, as when you first turn the key to "run", you should hear the fuel pump cycle. Your fuel pump is going out, I would ...
Access to fuel pump The pump is in the gas tank and tank must be removed for access. Remove the fuel tank.
fuel tank that fails it is very common on the blazers. very rarely have I seen it be the gauge in the dash itself on this vehicle. Unfortunately the sender is located inside of the fuel tank. the tank
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions