Questions & Answers for: Oldsmobile how to remove headlight

remove the headlight... remove the weather cover off the back of the headlight and pull the bulb out.. put the new bulb in but do not touch it... you should have an alcohol pad and clean the bulb with

Ad

...Headlight. Remove these and then remove the headlight. Once out, then just turn the bulb and remove. Be careful with the plastic clip that holds the bulb to the wiring harness. Since the car is old, ...

Ad

...advises it is installed from the front. remove the retainers from the back,and remove the headlight as a whole from the front,and replace the bulb inside,do not touch the new bulb on the glass

Question about 1998 88

1 Answer

...headlight bulb. For the seal beam unit you have to remove the outside trim. There are usually a couple of screw holding the trim in place. Do not confuse this with the headlight alignment or ...

bulb, then... ...turn the bulb and remove it from the headlight assembly. Step 4 Turn on the headlights and check high and low beams to verify repairs. Hope this help (remember comment and rated this)

Question about 1996 Achieva

1 Answer

...remove the headlight trim Remove the 4 headlight retaining ring screws (A). Do not confuse these with the aiming screws (B) Remove the headlight retaining ring, but make sure the headlight doesn't ...

remove the headlight assembly. Pull slightly outward from the side, then forward and away from the car. Step 5: Locate the correct bulb socket (high-beam/low-beam). Disconnect the wire connector using

Question about 1993 Cutlass Supreme

1 Answer

...This will expose the other two 10mm bolts on the headlight assembly. Remove the four 10mm bolts to remove the headlight assembly and this will allow you access to the headlight you need to

Remove the cover over the headlight this vehicle has five screws securing the cover other models may have four or six screws. 3. Remove the four screws which secure the retaining ring  around the

Question about 1996 Cutlass Ciera

1 Answer

...that hold grill. Set aside. Now remove four 10mm bolts, two on each side of headlight assembly, and remove. Twist and remove bulb and reinstall in new assembly. Reinstall in reverse of

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...