Remove the key from the lock cylinder. - Security indicator should be Flashing when the door is open. - Security indicator should be Off when all the doors are closed. - If the Security indicator does
key on push switch. Engine starts but dies. But no start at. Key also when hand held computer hooked up to adal Conn. Its reads after going thru diagnosis. Error can not read. Frustrated as hell"
...remove the gas tank to replace the fuel pump. Run the appropriate pressure test to determine if the fuel pump is staying pressured up and proceed accordingly. There is on reset that im aware of there ...
...remove a car alarm of 96 monte carlo 1998 ford ranger wont start alarm goes off i have a 96 ford explorer after coming home lastnight turning everything off an then turning my key off all sudden my ...
...remove the door panel to find it. The wire is dark green and purple. Splice into that wire and ground it to the chassis and the alarm should no longer work. It's when the security light starts ...
...remove the plastic covers around the steering wheel. Had to get a manual, but it was worth it for $15. All of the wires coming from most everything in the dash, gauges and all come up to a circuit ...
remove the key lock cylinder,place the key in the lock and rotate clockwise to the start or run position,then push in the retainer pin and pull the key and lock cylinder from the ignition switch, when
...key on. No volts check fuse 4WD instrument panel .driverside dash open door to remove cover. 2nd have voltage remove the actuator make sure it extends if not buy a new one. lots of 4X4'rs put in a ...
...bad key switch make truck hard to put in gear bad how? remove switch, cycle it with key and listen, hear clicks ? if not, lubricate, graphite best, tumblers should move freely and pins snap into ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions