...an identical fuse. Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or
...check the immersion heater will require you to pull out the washer from under the counter & to remove power from the appliance. Looking underneath the unit, remove a power lead from one side of ...
Question about Gold Duet GHW9400P 3.8 Cu. Ft. Front-Loading Washer
...an identical fuse. Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or
...not come back on after initial warming. Thanks. It sounds like you have a faulty timer. To test it, remove timer knob and remove screws. Remove screws from behind control panel. Disconnect leads from ...
...leading cause of so many problems with Sub-Zero refrig's is the coil behind the top grill above the doors is clogged with dust. You can use a vacuum with a hose to clean that coil by removing the ...
Question about 661/F Side by Side Refrigerator
...an identical fuse. Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or
Question about Tumble Dryer Heater/Thermostat (2957500600)
...an identical fuse. Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or
...an identical fuse. Temperature switch could be bad -- Use VOM to check the switch. Set VOM to RX1, remove leads and touch the probes to the switch's terminals. The reading should be zero or
Question about Tumble Dryer Heater/Thermostat (2957500600)
...zero off a UPC-A barcode even after scanning the config barcode to "Disable Remove Leading Zero". It there another setup affecting this? disable / remove leading 0 then set as default or apply ...
Question about Tumble Dryer Heater/Thermostat (2957500600)
...Good Thermopile. There is factory lead from the TH/TP terminal that goes to the safety magnet. If i remove this lead from the the flag terminal at TH/TP , the voltage from the Thermopile is back. ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions