Question about 2003 Windstar
...the car starts one time and then the same thing again no starter rotation until the batt. cable is removed and reconnected again...starter,relays,ign. switch,batt, all ck fine ..even the ford dealer ...
...vehicle new, there was an aftermarket security system installed. The system had a bad diode, so i removed the system and reconnected the factory
where is the starter located on 1985 Honda Civic? The starter is located on the firewall side of the engine block, adjacent to the flywheel or torque converter housing. Early models, use a direct ...
...connected to, back together. That is your car's starter wire. I'm assuming that you're the one who removed the alarm from your car and you know what wire I'm talking
...ignition and connected a relay. on the relay is one of your starter wire on the other is the other part of the starter wire remove the relay and establish the connection orginally and you are
...remove the device? Note the diagram. I wasn't sure of engine litre size? Is this what you have? Hope you can read it? Sometimes when relay doesn't show terminal numbers, it may mean the relay is ...
...bought 2010 chevy impala from auction. Has starter interrupter and GPS from out of business car lot. How can I remove the device to start the car. What do you mean? starter interrupter.
Question about 2010 Impala
After removing the starter interrupter how do I connect and start my vehicle What make , model and year vehicle ?
Question about 2010 Impala
...the starter and the alarm keeps going off Wondering what could be wrong The alarm is interrupting the starter signal circuit. Is this a factory installed (OEM) alarm, if not it is defective remove
Question about 2010 Impala
How do I disable the alarm on a 2007 MB ML 350? Is there a fuse I can remove? You really need a wiring diagram,as the starter interrupt is part of the circut,and you'll have to by pass it.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions