Questions & Answers for: removing drive belt vision fitness

...shroud and inspect the drive belt VF is imfamous for squealing drive belts better to call them and order a new belt here is their # 1-800-335 4348 Vision is now under there parent corp. name ...

...vision fitness treadmill. I turn on the treadmill and it starts at P1 and then it automatically goes through all the programs and sppeds until it gets to 10 miph. I have tried unplugging it. I have ...

...drive belt is on the motor. Try running it to see if the motor turns. This could be a motor or controller board problem. Try replacement of the mains power cable. They are of poor quality from ...

vision fitness premier threadmill console has power but is not going much more than vision premier boot ... ... ready for jump... ... see the chart attached. Tigh the upper and lower connector+ribbon ...

Vision fitness premier T9550 Console has power but is not going more than Vision premier boot... ... Ready for jump... ... than nothing else please see the chart attached. However Tight the upper and ...

Treadmill overspeed. After a few minutes of normal operation the treadmill RPM goes UP to the max and later stops. I try to perform the calibration but after running at slow speed the treadmill stops ...

...removing the motor cover and disconnecting and reconnecting some wires. I would suggest you get in touch with the manufacturer. Depending on the age of your unit, some warranty may apply. Refer to ...

I have a vision fitness t9550 running machine , and the Safe key magnet reed switch? has broken https://www.youtube.com/watch?v=Ww6Ns4GwhYw https://www.youtube.com/watch?v=l6VauCpABhQ

What does error E9 mean? https://content.johnsonfit.com/inc/uploaded_media/5909b6a4720ac96262abbd62767ed35d/troubleshooting_guide/87fc08ffe3e0caa8a9d3a1b15d59e71d.pdf User interface control board ...

Vision fitness treadmill t9550 won't start after emergency stop T9550/ tcp9 console. After pressing the emergency stop button the treadmill is stuck inclined and does not lower after resetting the ...