Questions & Answers for: Tannoy repair subwoofer humming

...Humming driver and check the configuration on both channels. If there is is problem then it has to do with driver and has to be recoiled and reconed ( ofcourse with a little quality lost) which could ...

No sound from subwoofer I have a subwoofer connected to the sub out jack of my reciever via a Monster cable. When I powered the unit up, there was no sound from the subwoofer, only the mains (2 ...

...subwoofer. It's about 4 years old. I know now that they are overpriced crap, but I am stuck with them. So, suddenly only one cube speaker output jack is working. I have a 5 cube speaker system, and ...

Sub Hum recently my Tannoy TS10 started to hum. I have read up on ground loop problems. If the sub is powered on by itself there is no hum, it is only when I connect the sub cable to the amp the hum ...

My Tannoy Reveal 5A Powered Monitors are producing a low hum. This is the case when in on or in standby mode, and is the case whether plugged in to an audio cable or not. Could you please assist with ...

I just need to know where to find TANNOY ?? My Reveal 6D needs repairing (...one has failed) Here you go - http://www.tannoy.com/

The audio connection has broken To the subwoofer where / how could I get this repaired, I'm based 20 miles west of London. Check w/ Studio supply (they have London office) Please contact the nearest ...

...Subwoofer is only making a humming sound and not working properly. It was working for several years and then the humming. No changes to connections or receiver. Is there a fuse I should check or some ...

How do I replace a fuse in the Tannoy TS10 Subwoofer The fuse is located under the AC input cable. Pull out the cable and you'll see there is a slot that will fitt a flat screwdriver. Pull this out ...

...repair?. The model is HF: 25mm (1") Nitro-Urethane layer damped woven polyester dome, neodymium magnet assembly. How to undo this box? I have to remove first the subwoofer? Do I need to control ...