Questions & Answers for: Chevrolet 1500 replace 4 wd switch

Question about 1991 K1500

1 Answer

4 wd ? I think you have a worn WHEEL BEARING. Place your truck on LEVEL SOLID ground. SCOTCH the rear tires, IF you are on dirt put a section of a 2"x10" board under your jack, jack up the right front

Ad

...4 WD uses excessive fuel (4.3 V6) '93 Chevy Cheyenne uses excessive fuel (determined its NOT the catalytic converter) and gas is getting into the charcoal canister. check for tune up check for vacuum ...

Ad

...4 WD 1500 Truck, Replace the light switch, if I am right the dash lights will be out, if this is the case post back here to give you detailed instructions on how to fix. Thanks for using fix-ya. ...

...4 wd to 2wd. No grinding no noise out of 4wd - but it appears to be the buttons inside the vehicle. Am I way off? No, I would say you are dead on! The gm pushbuttons for 4wd are notorious for that ...

Question about 1996 K1500

1 Answer

...switch on the 4 Wheel drive lever under the cover and also not sure of the voltage at the actuator and color code of the wires. any help will be appreciated. Bob Lathim USMC Ret. you also have a 4 ...

...4-wd truck. the temp guae volt meter oil pressure guage in the cluster all worked the rest did not. I found a replacement at a local scrap yard. now the temp volt and oil pressure still work . was ...

Question about 1988 K1500

1 Answer

...4 wd no noise, seems to be coming from transfer case 120000 miles when i let up on accel. its ok idrive for awhile and its fine please help thanks whats happening is the side gears in your transfer ...

...4 it sputters pretty bad replaced fuel pump fuel filter fuel pressor regulator egr valve checked the plugs what could it be? you could be dealing with a vacuum leak on the manifold. you can use some ...

...4 wd low select works, you need to shift it back into 4 wd high before continuing! When taking the truck out of 4wd to 2wd, I recommend the same, shift to neutral, select 2wd, back truck up, shift ...

Question about 1993 K1500

2 Answers

...replace brakeswitch still on if you unplug the brake switch does the lights go out? if the lights go out then it sounds as though the switch is not adjusted properly. I have replaced the brake light ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...